B&B Electronics ZXT9-MB2A-KIT - Manual - Manual (Page 39)

Document Number: ZXTxRM-5110m
Page
39
Pressing the Advanced Command Button will bring up the following screen.
Figure 5-23 Advanced Command Button
CC – Command Sequence :
The CC command is used to set/read the ASCII character used
between guard times of the AT Command Mode Sequence (BT + CC + AT). This sequenc
e enters the modem into AT Command Modeso that data entering the modem (from the h
ost) is recognized as a command instead of payload. The default value of 2B is equivalent
to “+” in ASCII.
BT – Guard Time Before & AT – Guard Time After : Sets the required period of silence
before, after and between the Command Mode Characters of the Command Mode
Sequence (GT + CC + GT). The period of silence is used to prevent inadvertent entrance
into AT Command Mode.
Return Button : The Return Button is used to return to the manager main screen.
Figure 5-24 Return Button