B&B Electronics ZXT9-MB2A-KIT - Manual - Manual (Page 59)

Document Number: ZXTxRM-5110m
Page
59
Section Six – Startup and Configuration
6.0 Startup and Configuration
6.1 Basic Settings
Figure 6-1 Radio Modem Basic Settings
6.1.1 Channel Number
This identifies the channel within the 900 MHz or 2.4 GHz band that you are using. The
channel you select must be the same on every Zlinx
® product you desire to communicate
with. If interference is experienced from other devices outside your control, you can
change to another channel to improve communications.
6.1.2 Network Identifier
The network identifier is used to separate Zlinx ® products into networks. The network
identifier must be the same on each product you desire to communicate with.
6.1.3 Baud Rate, Stop Bits, Parity, and Flow Control
Refer to section 5.3.2.1 and 5.3.2.2
6.2 Advanced Settings
Advanced modem tab is described in section five.