B&B Electronics OP10 - Manual - Manual (Page 60)

5 Communication
5.1. Communication port
OP10 has two communication ports:COM1 and RS485.COM1 is using for downloading
(writing) users’ program, and affords RS422 port. RS485 affords RS485 port.
1. 9-pin D-shape male plug (COM1)
Pin1
Num Name Description
1
TX+ 422 send positive signal
2 RX 232 receive signal
3 TX 232 send signal
4 NC (This pin connect to the CPU pin inside OP10. Low
level: The 232 communication port of OP10 is ready
to receive configuration data. High level: no use )
5 GND GND
6
TX- 422 send negative signal
7 RTS (VCC, give power supply to SG2 program cable)
8 RX- 422 receive negative signal
9 RX+ 422 receive positive signal
Pin9
2. RS485:
Num Name Description
1
A 485 positive signal
2 B 485 negative signal
3 SG 485 GND
57