B&B Electronics OP10 - Manual - Manual (Page 23)

Use the same method to set the current screen, which shows the output of B. The register
address is D1. Other properties are the same as A.
After downloading the configuration screens from PC to OP10, OP10 will demand the value
of D0 and D1. Then the value will be displayed on the screen in time. Users only need to put the
output of A in D0, B in D1. They do not need to care the communication between TP03 and OP10.
Example 2 Project Data
If the input voltage of TP03 AD module voltage is 0-10V, the value of the corresponding
register is 0-1023 and that users only want to show the current voltage, users can set project data.
Suppose the corresponding register with AD is D0.
20