B&B Electronics OP10 - Manual - Manual (Page 13)

„ If there are some data setting components in the screen, [ ] and [ ] key will execute
the function of value increase and decrease in the data setting mode. After quitting the
data setting mode, the [ ] and [ ] key will execute the basic function for screen
jumping.
„ Choose the communication port of the screen. Users can choose COM1/485 port as the
communication port of the current screen. Users also can set the COM1/485
communication port of OP10 to demand the data of different destination host at the
same time.
For example: Screen 1 can be set as communicating through 232; Screen 2 can be set as
communicating through 485.They are separate.
2.5.3 Configuration of OP10
Press or activate [Tools] [OP10 serial Set] command to pop up a dialog box for
configuring the system parameters of OP10:
„ Initial Screen
The first screen will be displayed after power on. Usually this screen is set to be the
main menu screen or the most-frequently-used screen. Press [ESC] when the OP10 is running,
the system will jump to this screen directly.
„ Screen Saver
Under default conditions, the backlight is set to be “never”. The time can be set by the
10