M&C TechGroup EC-30_FD Operator's manual - Manual (Page 8)

8
Gas sampling and gas conditioning technology 3-4.20-ME
6 INTRODUCTION
The patented M&C EC30 gas cooler with universal unit EC-F and EC-30/FD with unit EC-FD is always
to be installed in situations where there is interference from moisture in the gas to be measured, or if
the measured components exhibit very high sensitivity to water vapour or if long and expensive heated
sampling lines are to be avoided.
Reduction of the gas temperature inside the cooler to a stable and very low dew point effects a
condensing out of the sample gas. Dry gas leaves the gas cooler and passes into the analyser after
suitable filtration. When installing the EC30(/FD) gas cooler on site in a frost-free protective housing,
there is no need to use a heated sample line with a high energy consumption as long as the ambient
temperature does not fall below a value of -25

C.
6.1 SERIAL NUMBER
The type plate with the serial number is located at the side
panel of the cooler housing (19“ version).
Whenever you call M&C regarding questions or orders for the spares please give us the serial number
of your EC30.