Insert live or delay window, Insert live or delay window’ on pa, 47 f – EVS IPDirector Version 5.6 - May 2009 Part 6 User's Manual User Manual
Page 56
IPDirector Version 5.6 – User Manual – Part 6: Playout – Playlist Panel
EVS Broadcast Equipment – May 2009
Issue 5.6.D
47
•
select the Unknown radio button.
•
select the T/C OUT radio button and enter a timecode value
•
select the Duration radio button and enter a duration value
6. Click the OK button.
The element is inserted in the list before or after the selected element (depending
on the ‘Insert mode in playlist’ parameter of the Tools > Settings > Playlist >
Playlist / General category. For more information see the section 1.8.1 ‘General
Insert LIVE or DELAY Window
While inserting a train via the Insert LIVE or DELAY option of the Playlist
Element contextual menu, the Insert LIVE or DELAY window will open. This
window makes it possible to define an IN point and an OUT point for the train
which will be inserted into the playlist.
The window contains the following zones:
Field Description
From Which Feed?
The drop-down box displays all trains available on
the XNet network. If the corresponding recorder has
a defined name, this name is displayed in the list
otherwise its EVS technical name is displayed (i.e.:
29_XT1_REC1).
IN Zone
In this zone, the IN point of the inserted train can be
defined. It can either
•
be based on a calculation when a delay is
specified
•
be a fixed T/C value
IN Zone - Delay
This defines the delay which is applied to the
selected element when the element is on air within
the playlist. If the delay value exceeds the train
remaining capacity, a warning message will be
displayed. The value entered by the operator is still
accepted, as the capacity could be made available
before the element is on air, by removing some clips
stored on the selected server.
IN Zone – T/C IN
This defines the timecode from which the train will
be played on. If the T/C value is greater than the on-
air T/C of the element, a warning message will be
displayed.
OUT Zone
In this zone, the OUT point of the inserted train can
be defined. It can have one of the following values:
•
unknown
•
a fixed T/C value