EVS IPDirector Version 6.0 - November 2012 Part 4 User's Manual - Manual (Page 78)

Note
No guardbands are kept.
3.5.6. Derushing a Tape
Clip Settings
Settings specific to the naming of clips with the Derush digitization type are available.
They are explained in the next table.
Setting Option Description
Follow Clip
Name Format
String When this option is selected, the clip name format string set under
Tools > Settings > Autoname > Clip is applied to name clips.
The Clip Name field in the Clip Information pane is then dimmed.
Postfix Name
Counter When this option is selected, a incremental number is added at the
end of the clip name.
This option does not make the Clip Name field unavailable.
None, one or both options can be selected at the same time.
How to Create Several Clips from an Entire Tape
To digitize an entire tape or a portion of tape and create clips each time a timecode jump
exists on the tape, proceed as follows:
1. Use the transport functions to position the tape where you want to start the digitization
process.
2. Click the Stop button to stop the digitization process. Otherwise, the system will stop
at the end of the tape.
3.6. Digitizing a Batch of Clips
3.6.1. Purpose
In Batch Digitize Mode, several clips can be queued in a Batch list, so that they will all be
digitized in one process run.
3.6.2. Process Overview
The process of digitizing a batch of clips can be summarized by the following steps.
68 3. VTR Control Panel
EVS Broadcast Equipment S.A. - November 2012 Issue 6.00.A