EVS IPDirector Version 6.0 - November 2012 Part 4 User's Manual - Manual (Page 69)

The Keyword area allows you to assign up to five keywords to a digitized clip to qualify its
content.
You can proceed in three different ways.
You can start to type the keyword directly in the Keyword field and select a keyword
proposed in the Autocomplete list:
• You can select keywords in an open keyword grid or an open dictionary.
• You can type the number associated to a keyword in an open keyword grid.
Refer to section "Assigning Keywords to a Media" in the chapter "Keyword Management"
for a detailed procedure on how to assign keywords to a clip and how to un-assign
keywords.
Send To Destinations
The destinations where a digitized clip can be transferred to are listed below.
• the user's default bin, if any
• the default playlist, if any
• a default archive target
• any target destination visible on the GigE network that has been defined in the
Remote Installer (CleanEdit targets, Avid targets, Final Cut Pro targets, File targets,
XT targets).
• any nearline for which the user has appropriate right
• the EVS servers for which the user has visibility right
• the bins configured in IPDirector and for which the user has write access right.
3.2.6. Batch List Pane
Introduction
The Batch List pane provides the functions to digitize a list of clips at once.
Overview of the Batch List Pane
The Batch List pane contains the main areas highlighted on the following screenshots and
shortly described in the table below.
IPDirector - Version 6.00 - User Manual - Ingest Modules
3. VTR Control Panel 59