EVS INSIO Version 1.0 - October 2009 User's Manual - Manual (Page 61)

Issue 1.0.D INSIO Version 1.0 – User Manual
EVS Broadcast Equipment – October 2009
54
C
LIP
T
RANSPORT
, E
DIT AND
T
RANSFER
F
UNCTIONS
This area provides the functions required to play a clip and move within the
material. A jog wheel allows you to move through the loaded media in three
different modes. Buttons used for clip editing and transfer are available as well.
It also contains time information fields:
TC IN field : displays the IN point timecode of the clip being reviewed.
TC Dur field : displays the time interval between the IN and OUT points, i.e.
duration of the clip being reviewed.
TC OUT field : displays the OUT point timecode of the clip being reviewed.
TC Current : when the clip is being played, displays the current timecode position.
This field can also be used to enter a timecode value to jump to.
5.4.3 L
OADING
M
EDIA
To review a recorded clip, you need to load it on a video playback channel.
It can be loaded just after its recording from the Record tab, or, later on, from the
Left Clip List tab. The operation can be performed manually or automatically.
L
OADING
L
AST
R
ECORDED
C
LIPS ON
P
LAYER
C
HANNELS
You have the possibility to visualize the take you have just recorded in the Record
tab, even if the take has not yet been saved on the server. You can do this in
three different ways:
• manually, by selecting the clips and the player channels one by one
• manually, by selecting a preset playback channel configuration
• automatically, by selecting the Auto-Review mode and a preset playback
channel configuration
Presets of playback channel configurations are intended to automatically load a
selection of camera angles in a single click.
Loading Clips Manually One by One
When the Auto Review function is not activated and you want to load some of the
clip(s) you have just recorded, proceed as follows:
1. From the Record tab, select the clip you want to review.
The corresponding camera/clip line is highlighted.
2. From the Review tab, select the player channel you want to load the clip
onto.
The corresponding player channel line is highlighted.