ZyXEL Communications 660HW Series - Manual (Page 85)

Prestige 660H/HW Series User’s Guide
Chapter 7 Wireless LAN (Prestige 660HW) 84
6 If you have OTIST-enabled clients, configure OTIST in the OTIST screen. OTIST
transfers device SSID and WEP or WPA-PSK key settings (if enabled) to wireless
clients.
The following figure shows the relative effectiveness of these wireless security methods
available on your Prestige.
Figure 25 Wireless Security Methods
Note: You must enable the same wireless security settings on the Prestige and on all
wireless clients that you want to associate with it.
If you do not enable any wireless security on your Prestige, your network is
accessible to any wireless networking device that is within range.
7.3 Configuring the Wireless Screen
7.3.1 WEP Encryption
WEP encryption scrambles the data transmitted between the wireless stations and the access
points to keep network communications private. It encrypts unicast and multicast
communications in a network. Both the wireless stations and the access points must use the
same WEP key.
Your Prestige allows you to configure up to four 64-bit, 128-bit or 256-bit WEP keys but only
one key can be enabled at any one time.
In order to configure and enable WEP encryption; click Wireless LAN and Wireless to the
display the Wireless screen.