ZyXEL Communications 660HW Series - Manual (Page 448)

Prestige 660H/HW Series User’s Guide
447
Log Commands
Go to the command interpreter interface ( Appendix I on page 430 explains how to access and
use the commands).
Configuring What You Want the Prestige to Log
1 Use the sys logs load command to load the log setting buffer that allows you to configure
which logs the Prestige is to record.
2 Use sys logs category to view a list of the log categories.
Figure 270 Displaying Log Categories Example
Copyright (c) 1994 - 2004 ZyXEL Communications Corp.
ras> ?
sys exit device ether
wan poe config wlan
ip ppp bridge hdap
bm lan radius 8021x
P660>
3 Use sys logs category followed by a log category to display the parameters that are
available for the category.
Figure 271 Displaying Log Parameters Example
ras> sys logs category access
Usage: [0:none/1:log/2:alert/3:both]
ras>
4 Use sys logs category followed by a log category and a parameter to decide what to
record.
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to
record only alerts for that category, and 3 to record both logs and alerts for that category.
Not every parameter is available with every category.
5 Use the sys logs save command to store the settings in the Prestige (you must do this in
order to record logs).
Displaying Logs
• Use the sys logs display command to show all of the logs in the Prestige’s log.
• Use the sys logs category display command to show the log settings for all of the log
categories.
• Use the sys logs display [log category] command to show the logs in an individual
Prestige log category.
• Use the sys logs clear command to erase all of the Prestige’s logs.