ZyXEL Communications 660HW Series - Manual (Page 257)

Prestige 660H/HW Series User’s Guide
Chapter 26 Remote Node Configuration 256
Figure 141 Sample IP Addresses for a TCP/IP LAN-to-LAN Connection
26.4 Remote Node Filter
Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select
Yes. Press [ENTER] to display Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between this remote node and the Prestige and also to prevent certain packets
from triggering calls. You can specify up to 4 filter sets separated by comma, for example, 1,
5, 9, 12, in each filter field.
Note that spaces are accepted in this field. The Prestige has a prepackaged filter set,
NetBIOS_WAN, that blocks NetBIOS packets. Include this in the call filter sets if you want to
prevent NetBIOS packets from triggering calls to a remote node.
Figure 142 Menu 11.5 Remote Node Filter (RFC 1483 or ENET Encapsulation)
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: