2 the reset button, 1 using the reset button, 2 web configurator main screen – ZyXEL Communications P-2608HWL-Dx Series User Manual
Page 48: Figure 8 main screen, Ab c d
P-2608HWL-Dx Series User’s Guide
48
Chapter 2 Introducing the Web Configurator
2.1.2 The RESET Button
You can use the RESET button on the side of the device to reboot the device. If you forget
your password or cannot access the web configurator, you will need to use the RESET button
to reload the factory-default configuration file. This means that you will lose all configurations
that you had previously and the password will be reset to “1234”.
2.1.2.1 Using The Reset Button
1 Make sure the POWER light is on (not blinking).
2 Do one of the following.
To set the device back to the factory default settings, press the RESET button for ten
seconds or until the POWER light begins to blink. When the POWER light begins to
blink, the defaults have been restored and the device restarts.
You can also use the reset button to activate OTIST by pressing the RESET button for 5
seconds. See
for more information on OTIST.
2.2 Web Configurator Main Screen
Figure 8 Main Screen
As illustrated above, the main screen is divided into these parts:
• A - title bar
A
B
C
D