ZyXEL Communications P-2608HWL-Dx Series - Manual (Page 100)

P-2608HWL-Dx Series User’s Guide
100 Chapter 7 WAN Setup
Figure 49 WAN More Connections > Modify
The following table describes the labels in this screen.
Table 27 WAN More Connections > Modify
LABEL DESCRIPTION
General
Active Use this checkbox to activate or deactivate this WAN connection.
Name Give a name to this WAN connection. This if for descriptive purposes only.
Mode Select Routing (default) from the drop-down list box if your ISP allows multiple
computers to share an Internet account. Otherwise select Bridge.
Encapsulation Select the method of encapsulation used by your ISP from the drop-down list box.
Choices vary depending on the mode you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP
or PPPoE.
User Name (PPPoA and PPPoE encapsulation only) Enter the user name exactly as your ISP
assigned. If assigned a name in the form user@domain where domain identifies a
service name, then enter both components exactly as given.
Password (PPPoA and PPPoE encapsulation only) Enter the password associated with the
user name above.
Service Name (PPPoE only) Type the name of your PPPoE service here.