ZyXEL Communications P-2608HWL-Dx Series - Manual (Page 157)

P-2608HWL-Dx Series User’s Guide
Chapter 11 SIP 157
11.1.10 MWI (Message Waiting Indication)
Enable Message Waiting Indication (MWI) enables your phone to give you a message–
waiting (beeping) dial tone when you have a voice message(s). Your VoIP service provider
must have a messaging system that sends message waiting status SIP packets as defined in
RFC 3842.
11.1.11 Custom Tones (IVR)
IVR (Interactive Voice Response) is a feature that allows you to use your telephone to interact
with the ZyXEL Device. The ZyXEL Device allows you to record custom tones for the Caller
Ringing Tone and On Hold Tone functions. The same recordings apply to both the caller
ringing and on hold tones.
11.1.11.1 Recording Custom Tones
Use the following steps if you would like to create new tones or change your tones:
1 Pick up the phone and press “****” on your phone’s keypad and wait for the message
that says you are in the configuration menu.
2 Press a number from 1101~1108 on your phone followed by the “#” key.
3 Play your desired music or voice recording into the receiver’s mouthpiece. Press the “#”
key.
4 You can continue to add, listen to, or delete tones, or you can hang up the receiver when
you are done.
11.1.11.2 Listening to Custom Tones
Do the following to listen to a custom tone:
1 Pick up the phone and press “****” on your phone’s keypad and wait for the message
that says you are in the configuration menu.
2 Press a number from 1201~1208 followed by the “#” key to listen to the tone.
3 You can continue to add, listen to, or delete tones, or you can hang up the receiver when
you are done.
11.1.11.3 Deleting Custom Tones
Do the following to delete a custom tone:
Table 54 Custom Tones Details
LABEL DESCRIPTION
Total Time for All Tones 120 seconds for all custom tones combined
Time per Individual Tone 20 seconds
Total Number of Tones
Recordable
8
You can record up to 8 different custom tones but the total time must be
120 seconds or less.