ZyXEL Communications P-2608HWL-Dx Series - Manual (Page 126)

P-2608HWL-Dx Series User’s Guide
126 Chapter 9 Wireless LAN
Figure 63 Wireless: Static WEP Encryption
The following table describes the wireless LAN security labels in this screen.
9.5.3 WPA(2)-PSK
In order to configure and enable WPA-PSK authentication; click Network > Wireless LAN to
display the General screen. Select WPA-PSK or WPA2-PSK from the Security Mode list.
Table 37 Wireless: Static WEP Encryption
LABEL DESCRIPTION
Security Mode Choose Static WEP from the drop-down list box.
Passphrase Enter a Passphrase (up to 32 printable characters) and clicking Generate. The ZyXEL
Device automatically generates a WEP key.
WEP Key The WEP key is used to encrypt data. Both the ZyXEL Device and the wireless
stations must use the same WEP key for data transmission.
If you want to manually set the WEP key, enter any 5, 13 or 29 characters (ASCII
string) or 10, 26 or 58 hexadecimal characters ("0-9", "A-F") for a 64-bit, 128-bit or
256-bit WEP key respectively.