ZyXEL Communications GS-4024 - Manual (Page 411)

GS-4012F/4024 User’s Guide
411
C
H A P T E R
5 0
Multicast VLAN Registration
Commands
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.
50.1 Overview
Use the mvr commands in the configuration mode to create and configure multicast VLANs.
"
If you want to enable IGMP snooping see Section 47.2 on page 383 .
50.2 Create Multicast VLAN
Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr
mvr source-port
mvr receiver-port
mvr inactive
mvr mode
mvr name
mvr tagged
mvr group start-address end-address
mvr exit
where
= The VLAN ID [1 – 4094].
source-port = Specifies the MVR source ports which send and receive multicast
traffic.
receiver-port = Specifies the MVR receiving ports which only receive multicast
traffic.
name = A name to identify the multicast VLAN group.