ZyXEL Communications GS-4024 - Manual (Page 404)

Chapter 49 IEEE 802.1Q Tagged VLAN Commands
GS-4012F/4024 User’s Guide
404
49.2 Global VLAN1Q Tagged VLAN Configuration Commands
This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
49.2.1 GARP Status
Syntax:
show garp
This command shows the Switch’s GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.
49.2.2 GARP Timer
Syntax:
garp join leave leaveall
where
This command sets the Switch’s GARP timer settings, including the join, leave and leave all
timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All
message terminates all registrations. GARP timers set declaration timeout values.
sysname# show garp
GARP Timer
------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
sysname#
join = This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed Join Time
range is between 100 and 32767 milliseconds; the default is 200
milliseconds.
leave = This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600
milliseconds.
leaveall = This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.