ZyXEL Communications GS-4024 User Manual
Page 369
Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
369
egress
Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
ard|network> Sets how Bridge Protocol Data 13 broadcast-limit Enables broadcast storm control 13 Specifies the maximum number of 13 dhcp snooping trust Sets this port as a trusted DHCP 13 dhcp snooping limit rate Sets the maximum rate that 13 diffserv Enables DiffServ on the port(s). 13 dlf-limit Enables the Destination Lookup 13 Sets the interface DLF limit in 13 egress set list> Sets the outgoing traffic port list 13 ethernet oam Enables Ethernet OAM on the 13 mode Specifies active or passive OAM 13 remote-loopback supported Enable Ethernet OAM remote- 13 exit Exits from the interface port- 13 flow-control Enables interface flow control. 13 frame-type ged> Choose to accept both tagged 13 Table 140 interface port-channel Commands (continued) COMMAND DESCRIPTION PRIVILEGE
Units (BPDUs) are used in STP
port states.
limit on the port(s).
broadcast packets to allow
through the port.
snooping port. Trusted ports are
connected to DHCP servers or
other switches, and the Switch
discards DHCP packets from
trusted ports only if the rate at
which DHCP packets arrive is too
high.
DHCP packets are allowed to
arrive at a trusted DHCP snooping
port.
Failure (DLF) limit.
packets per second (pps).
for a port-based VLAN.
port(s).
mode on the ports. Active mode
allows the port to issue remote
loopback and discovery
commands. Passive mode means
that the port can only respond to
Ethernet OAM commands.
loopback capability on the port(s).
channel command mode.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
and untagged incoming frames,
just tagged incoming frames or
just untagged incoming frames on
a port.