ZyXEL Communications NWA-3160 Series - Manual (Page 69)

Chapter 4 Tutorial
ZyXEL NWA-3160 Series User’s Guide
69
Each SSID profile already uses a different pre-shared key.
In this example, you will configure access limitations for each SSID profile. To do this, you
will take the following steps.
1 Configure the SERVER_1 network’s SSID profile to use specific MAC filter and layer-2
isolation profiles.
2 Configure the SERVER_1 network’s MAC filter profile.
3 Configure the SERVER_1 network’s layer-2 isolation profile.
4 Repeat steps 1 ~ 3 for the SERVER_2 network.
5 Check your settings and test the configuration.
To configure layer-2 isolation, you need to know the MAC addresses of the devices on your
network, which are as follows.
To configure MAC filtering, you need to know the MAC addresses of the devices Alice and
Bob use to connect to the network, which are as follows.
4.4.4 Configure the SERVER_1 Network
First, you will set up the SERVER_1 network which allows Alice to access secure server 1 via
the network switch.
You will configure the MAC filter to restrict access to Alice alone, and then configure layer-2
isolation to allow her to access only the network router, the file server and the Internet security
gateway.
Take the following steps to configure the SERVER_1 network.
1 Log into the ZyXEL Device’s Web Configurator and click WIRELESS > SSID. The
following screen displays, showing the SSID profiles you already configured.
Security Security Profile security03:
WPA2-PSK
Hide SSID
Security Profile security04:
WPA2-PSK
Hide SSID
Intra-BSS traffic
blocking
Enabled Enabled
Table 8 Tutorial: Example Network MAC Addresses
DEVICE LABEL MAC ADDRESS
ZyXEL Device Z BB:AA:99:88:77:66
Secure Server 1 1 AA:99:88:77:66:55
Secure Server 2 2 99:88:77:66:55:44
Workstation C 88:77:66:55:44:33
Switch D 77:66:55:44:33:22
Security gateway E 66:55:44:33:22:11
Table 9 Tutorial: Example User MAC Addresses
USER MAC ADDRESS
Alice 11:22:33:44:55:66
Bob 22:33:44:55:66:77
Table 7 Tutorial: SSID Profile Security Settings