Auto configuration by dhcp, Manual configuration, Configuration via snmp – ZyXEL Communications NWA-3160 Series User Manual
Page 298
Appendix F Text File Based Auto Configuration
ZyXEL NWA-3160 Series User’s Guide
298
"
If adjacent APs use the same configuration file, you should leave out the
channel setting since they could interfere with each other’s wireless traffic.
Auto Configuration by DHCP
A DHCP response can use options 66 and 67 to assign a TFTP server IP address and a
filename. If the AP is configured as a DHCP client, these settings can be used to perform auto
configuration.
If this feature is enabled and the DHCP response provides a TFTP server IP address and a
filename, the AP will try to download the file from the specified TFTP server. The AP then
uses the file to configure wireless LAN settings.
"
Not all DHCP servers allow you to specify options 66 and 67.
Manual Configuration
Use the following command to manually configure a TFTP server IP address and a file name
for the AP to use for auto provisioning whenever the AP starts up. See
for how to access the Command Interpreter (CI).
Configuration Via SNMP
You can configure and trigger the auto configuration remotely via SNMP.
Use the following procedure to have the AP download the configuration file.
Table 117 Auto Configuration by DHCP
COMMAND
DESCRIPTION
wcfg autocfg dhcp [enable |
disable]
Turn configuration of TFTP server IP address and
filename through DHCP on or off.
Table 118 Manual Configuration
COMMAND
DESCRIPTION
wcfg autocfg server [IP]
[filename]
Specify the TFTP server IP address and file name from
which the AP is to download a configuration file whenever
the AP starts up.
Table 119 Configuration via SNMP
STEPS
MIB VARIABLE
VALUE
Step 1
pwTftpServer
Set the IP address of the TFTP server.
Step 2
pwTftpFileName
Set the file name, for example, g3000hcfg.txt.