ZyXEL Communications NWA-3160 Series - Manual (Page 142)

Chapter 12 Remote Management Screens
ZyXEL NWA-3160 Series User’s Guide
142
12.2 Configuring Telnet
You can configure your ZyXEL Device for remote Telnet access as shown next. The
administrator uses Telnet from a computer on a remote network to access the ZyXEL Device.
Figure 85 Telnet Configuration on a TCP/IP Network
Click REMOTE MGNT tab to display the TELNET screen as shown.
Figure 86 Remote Management: Telnet
The following table describes the labels in this screen.
Table 48 Remote Management: Telnet
LABEL DESCRIPTION
TELNET
Server Port You can change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Server
Access
Select the interface(s) through which a computer may access the ZyXEL Device
using Telnet.
Secured
Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
ZyXEL Device using this service.
Select All to allow any computer to access the ZyXEL Device using this service.
Choose Selected to just allow the computer with the IP address that you specify to
access the ZyXEL Device using this service.
SSH