ZyXEL Communications NWA-3160 Series - Manual (Page 236)

Chapter 25 System Maintenance and Information
ZyXEL NWA-3160 Series User’s Guide
236
Figure 164 Valid CI Commands
25.1.1 Command Syntax
• The command keywords are in courier new font.
• Enter the command keywords exactly as shown, do not abbreviate.
• The required fields in a command are enclosed in angle brackets <>.
• The optional fields in a command are enclosed in square brackets [].
• The |symbol means or.
For example,
sys filter netbios config
means that you must specify the type of netbios filter and whether to turn it on or off.
25.1.2 Command Usage
A list of valid commands can be found by typing help or ? at the command prompt. Always
type the full command. Type exit to return to the SMT main menu when finished.
25.1.3 Brute-Force Password Guessing Protection
The following describes the commands for enabling, disabling and configuring the brute-force
password guessing protection mechanism for the password.
25.1.3.1 Configuring Brute-Force Password Guessing Protection: Example
sys pwderrtm 5
This command sets the password protection to block all access attempts for five minutes after
the third time an incorrect password is entered.
Copyright (c) 1994 - 2007 ZyXEL Communications Corp.
NWA-3160> help or ?
Valid commands are:
sys exit ether wlan
ip bridge bm certificates
radius 8021x radserv wcfg
rogueAP
NWA-3160>
Table 91 Brute-Force Password Guessing Protection Commands
COMMAND DESCRIPTION
sys pwderrtm This command displays the brute-force guessing password protection settings.
sys pwderrtm 0 This command turns off the password’s protection from brute-force guessing. The
brute-force password guessing protection is turned off by default.
sys pwderrtm N This command sets the password protection to block all access attempts for N (a
number from 1 to 60) minutes after the third time an incorrect password is entered.