System name settings – TANDBERG 1700 MXP User Manual
Page 63
D 13954.01
MAY 2006
3
TANDBERG 1700
MXP
USER GUIDE
System Name Settings
Control Panel > General Settings
Touch tones
Snapshot
Presets
Touch tones
Snapshot
Presets
SYSTEM NAME
Identifies the system:
On the welcome screen of your system
During an MCU conference call
When using the Web-interface
When the codec is acting as an SNMP Agent
Towards a DHCP server
As H323 ID. If H.323 ID is configured in
it will be used instead of System Name.
System Name is blank by default, can be alphanumeric,
and up to 50 characters long.
•
•
•
•
•
•
INTERNATIONAL NAME
If the System Name contains Asian and non-standard
ASCII character text input (includes even languages like
Norwegian, French, Polish etc.), an International Name
using standard ASCII characters only, must be specified
as well.
If you set the language to e.g. Korean and input a System
Name using Korean characters, the International Name
field allowing you to specify the name using standard
ASCII character set will appear.
ENTERING A SYSTEM NAME
Whenever alphanumerical entries are expected by the system, a
small
abc
appears in the right lower corner of the entry field.
In this mode, entries from the
Numerical keypad
are automatically
interpreted as alphanumeric entries in the same way as on a cellular
phone.
Guidelines:
Press the key that corresponds to the required letter.
Press the key as many times as needed to access the
correct letter.
Change to lower or back to upper case letters with the
#
a/A
key, and space with the
0 _
key.
To write numbers in a text input field, repeatedly press the
corresponding key a number of times until the digit appears.
•
•
•
•
CANCEL
Select this icon and press
OK
to leave the menu undoing any
changes.
RESTORE DEFAULTS
Select this icon and press
OK
to restore the default settings.
SAVE
Select this icon and press
OK
to leave the menu putting
changes into effect.