TANDBERG 1700 MXP - Manual (Page 110)

D 13954.01
MAY 2006 110
TANDBERG 1700 MXP
USER GUIDE
IP Settings (I)
Control Panel > Network Settings > LAN Settings
CANCEL
Select this icon and press OK
to leave the menu undoing any
changes.
RESTORE DEFAULTS
Select this icon and press OK
to restore the default settings.
SAVE & RESTART
Select this icon and press OK
to leave the menu restarting
the system to put IP Setting
changes into effect.
IP SETTINGS
Remember to restart the system after making
changes to IP Settings. Click on the
Save & Restart
button to do this. Changes in IP Settings menu will
have no effect until the system is restarted.
IP PROTOCOL
IPv
. IP version 4 supported.
IPv . IP version 6 supported. IP Address, IP Sub-
net Mask, and Gateway will be disabled.
Both . Both IP version 4 and IP version 6 sup-
ported.
IP-ASSIGNMENT
DHCP (Dynamic Host Configuration Protocol)
can be selected when a DHCP server is present.
Note that for IPv6, DHCP is used for NTP / DNS
Server Addresses.
DHCP . IP-address, IP-subnet mask and Gateway
are not used because the DHCP server assigns
these parameters.
Static . The system’s IP-address, IP-subnet mask
and Gateway must be specified in the IP-address
field.
IP-ADDRESS
IP-address defines the network address of the
codec. This address is only used in static mode.
In DHCP-mode, the assigned IP-address can be
found on the Welcome Menu.
IP-SUBNET MASK
IP-subnet mask defines the type of network. This ad-
dress is only used in static mode. Your LAN-administra-
tor will provide the correct value for this field.
GATEWAY
When using DHCP, the default gateway will be
set automatically. If the LAN utilizes static IP ad-
dresses, IP address, subnet mask, and default
gateway must be specified by the LAN adminis-
trator.
Lower part of the menu is explained overleaf.
SAVE
Select this icon and press OK to leave
the menu saving the changes. Note
that restart is needed to put changes
into effect here!
Touch tones Snapshot
Camera Presets
Touch tones Snapshot
Camera Presets