Making video calls manually, Making telephone calls manually, Choosing between video and telephone call – TANDBERG 1700 MXP User Manual
Page 26: Dialling manually
D 13954.01
JUNE 2006
2
TANDBERG 1700
MXP
USER GUIDE
Making Point-to-Point Video & Telephone Calls Manually
Call Handling
Select
Make a Call
from the menu,
or, press the green
Call
key on the remote control.
The TANDBERG system can make both Video calls and
Telephone calls. Telephone calls over IP may require
additional hardware and infrastructure. If in doubt contact
your administrator or your TANDBERG representative.
Do one of three things:
•
Place the call by pressing
OK
so that the
Place Call
icon is selected and press
OK
once again
•
Use the
Arrow
keys on the remote control to select the
Place Call
icon and press
OK
•
Press the green
Call
key on the remote control.
Make sure
Video Call
is selected (as shown here). If not,
see below for details.
Enter the dial number manually using the
Numerical
Keypad.
When dialling manually, observe the guidelines given in
. Use
*
as separator in IP
addresses. If a system is registered on a gatekeeper or
border controller with DNS support, there are several
ways to call into the system:
See
for details
•
•
•
•
•
Touch tones
Snapshot
Presets
Do as described above for a video call, but make sure
Telephone Call
is selected.
Making Video Calls Manually
Making Telephone Calls Manually
Choosing Between Video and Telephone Call
Use the
Arrow
keys, navigate
to the
Call Type
icon, and click
OK
. Select the type of call and
click
OK
to exit the submenu.