Mapping dpm aux buses, Dpm map aux buses menu – Tektronix Grass Valley 3000 User Manual

Page 80

2-44

Section 2 — Startup & Configuration

NOTE:

Increasing the EFF SEND DELAY any further will not change

the Effects Send appearance. It will, however, delay the entry into Effects
Send unnecessarily.

Mapping DPM Aux Buses

Set up the aux bus-to-device assignment as follows:

From the DPM Setup Menu, press

DPM MAP AUX BUSES>

access the DPM Map Aux Buses Menu.

Press the

DEVICE SELECT

button to select the desired DEVICE

(1 through 4).

For Kaleidoscope

, rotate the

NUMBER OF CHANNELS

knob to

assign Aux Buses 1 through n to this DPM number. Turn the

FIRST CHANNEL

knob to assign the first aux bus to the first

physical channel of the DPM.

DPM MAP AUX BUSES MENU

DEVICE

SELECT

DPM 1

AUX 5

CHAN A

AUX 6

CHAN B

MISC

PHYS CHAN

DPM 2

DPM 3

DPM 4

NUMBER OF CHANNELS

= 4

FIRST CHANNEL

= CHAN E

CHAN D

CHAN F

CHAN G

CHAN H

CHAN E

AUX 7

CHAN C

config / extern if / dpm setup / dpm map aux buses

DPM 1

AUX3

AUX 4

AUX 2

AUX 1

Connection of physical AUX buses

to physical channels