Operating the model 3000 with kaleidoscope, To enable the model 3000, To enable kaleidoscope – Tektronix Grass Valley 3000 User Manual
Page 106
2-70
Section 2 — Startup & Configuration
Operating the Model 3000 With Kaleidoscope
After the Model 3000 has been connected to a Kaleidoscope DPM
(Digital Picture Manipulator), as described in the Installation
section of the Model 3000 Installation & Service manual, and after
the Model 3000 has been properly configured, as described earlier
in this section, all that is required for the two devices to operate
together is to enable both of them.
With both ends of the 3000/Kaleidoscope interface enabled,
communication is established which provides E-MEM recall and
run control.
To Enable the Model 3000
1.
Turn on (high tally) the
DPM
button that was configured for
Kaleidoscope (usually
DPM 1
) on the E-MEM Enables
subpanel.
2.
Bring up the DPM Setup Menu on the Model 3000 as follows:
a.
Press
CONFG
on the main menu panel.
b. Select
EXTERN I/F>
in the Configuration Menu.
c.
Select
DPM I/F>
in the External Interface Menu.
3.
Set the
DPM TYPE
in the 3000 DPM Setup Menu
to
KSCOPE.
To Enable Kaleidoscope
1.
Press the Kaleidoscope Top Menu
RESRCES
button.
2.
Select
USER PREFS
in the Resources Menu.
3.
Select
EXTRN CNTRL
in the User Preferences Menu.
4.
Select
ENABLE 3/4000
in the External Control Menu.