Tektronix Grass Valley 3000 - Manual (Page 190)

4-52
Section 4— Switcher Operations
E-MEM Learn Sequence Operations
Sequences made up of a series of learned registers can be easily
built using the Learn Sequence mode.
Learning A Sequence
This procedure will make use of effects previously stored in
registers 23 through 27.
1. Press LRN .
2. Press SEQ .
3. Press BANK 2 , then 3 (register 23).
4. Enter a 30 frame (1 second) “pause” after the register executes
– press
TRAN RATE (for transition rate), and 30 , followed by
ENTER .
5. Repeat Steps 3 and 4 for registers 24 – 27. After each register
number, you may learn a different transition rate by entering
a new transition rate as in Step 4 above.
6. Force an end to the sequence by turning off LRN.
— OR —
7. To create a looping sequence, select register 23 again to make
it the last register in the sequence.
8. Press LRN or SEQ again to complete the learn sequence.