Configuring outputs, Outputs menu – Tektronix Grass Valley 3000 User Manual
Page 62
2-26
Section 2 — Startup & Configuration
Configuring Outputs
The signal formats of the Model 3000 output modules for your
installation are set up from the Outputs Menu.
1.
Press the
CONFG
button on the main menu subpanel.
2.
From the Configuration Menu, select
OUTPUTS>
to display
the Outputs Menu.
3.
Select the output to change from the default setting by
pressing the
OUTPUT SELECT
button.
4.
Set the characteristics of the selected output, as follows:
SUPERBLACK
— Turns the superblack output
ON
or
OFF
. (The
Superblack output level is set in the System Parameters Menu,
as described previously.)
Refer to the Super Black Application Note in the Appendices
section of this manual for information on using Super Black.
SETUP ON KEY
— Selects or deselects setup on the key output
signal.
OUTPUTS MENU
ON
ON
config / outputs
CHROMA CLIP
= 105 %
LUM CLIP
= 105 IRE
ON
COMPOSITE CLIP
= 138 IRE
SHAPED
PGM
M/E 1 PGM
M/E 2 PGM
M/E 3 PGM
AUX BUS 1
AUX BUS 2
AUX BUS 3
AUX BUS 4
AUX BUS 5
AUX BUS 6
AUX BUS 7
FRAMESTORE
ON
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
-
-
-
-
-
-
-
-
-
-
-
-
-
-
SHAPED
SHAPED
SHAPED
UNSHAPED
-
-
-
-
BLACK CLIP
= -20 IRE
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
UNSHAPED
OFF
OFF
OFF
PGM
OFF
ON
SHAPED
OFF
SUPER
BLACK
OUTPUT
SELECT
SETUP
ON KEY
VIDEO/KEY
FMT
OUTPUT
TIMING >
LIMITER
DIGITAL
RES >