Toshiba G8000 - Manual (Page 15)

7 G8000 Series Installation and operation Manual
CAUTION
DO NOT transport, move, store, or place the UPS on its side.
Forces due to heavy components inside may damage the UpS.
Avoid vibration or shock exceeding 0.5G.
Failing to observe this precaution may cause damage to the UpS.
DO NOT allow the UPS to suffer shock or impact when
unpacking.
Tools used to remove packaging materials may cause damage to the
UpS.
DO NOT push or pull on the sides of the packaging.or the
UPS to move it. Always use a crane, forklift, or pallet jack for
transporting and positioning the UPS.
pushing/pulling on the sides of the unit to move it may result in damage
to the UpS. See Figure 4.1 exterior Handling label.
Fig. 4.1 exterior Handling label
FORKS (4�Ft.�Minimum�length)
WARNING:
Risk�of�tipping. For�safe�handling,�lift
from�back�and�sides�only�(as�shown�above) UPS
Do�not�push�or
pull�from�sides
BA
CK�SIDE
Do�not�push�or
pull�from�sides
BY CRANE
BY FORKLIFT
See�manual�for�complete�details.
:
-�Cables�should�have�sufficient�rating
and�equal�length.
-�Keep�UPS�leveled�when�lifting/lowering
and�avoid�impacts.
:
-�Verify�forklift�maximum�load�capacity.
-�Ensure�that�the�forks�are�long�enough
to�support�the�UPS�and�are�inserted
properly.
-�Do�not�swing�or�tilt�the�UPS��when
lifting�and/or�transporting.