Overland Storage REO 9000 - Manual (Page 56)

56 X Configuring the Management System
Overland Storage REO 9000 with ProtectionPAC Software
3 Click Apply.
4 Repeat these steps for Data Port 2 using an IP address that falls within
the Data Port 2 subnet.
Tip: Overland Storage recommends that you use a ping command to
ensure that the management system sees each port on the REO
Appliance.
5 If you purchased the FC-enabled REO Appliance, continue the
configuration process by entering the FC information described in the
next section; otherwise, proceed to the subsequent section,
Entering the
System Information on page 57.
Entering the Fibre Channel Information
1 In the right pane, scroll down to the Fibre Channel Configuration
section.
2 For each FC port (the REO Appliance provides two), select the applicable
settings from the Set Link Speed and Set Link Topology lists.
„ For link speed, select Auto, 1 GB, or 2 GB.
„ For topology, select Auto, Fabric/Point-to-Point (N_Port), or Loop
(NL_Port).
3 Click Apply.
4 Continue the configuration process by configuring the system
information as described in the next section.
Select the applicable
settings for each
Fibre Channel port.