Editing the configuration file, For a non-dhcp or unix management system), Management system) – Overland Storage REO 9000 User Manual
Page 33
Editing the Configuration File (for a non-DHCP or UNIX Management System)
W
33
Setup Guide
Editing the Configuration File
(for a non-DHCP or UNIX Management System)
1
With the key still inserted into a USB port on a Windows 2000, 2003, or
XP system that contains active virus-protection software, browse to the
software-key disk drive.
2
Open the ipkey folder, and locate the ifcfg-eth0 file.
The ifcfg-eth0 is the configuration file for the Management Port on the
REO Appliance.
3
Right-click the ifcfg-eth0 file, and click Properties.
4
On the General tab, if the Read-only check box is selected, clear it, and
then click OK; otherwise, click Cancel.
5
Right-click the ifcfg-eth0 file again, click Open With, and then select
WordPad (or a comparable text editor).
Tip:
Overland Storage recommends that you use WordPad, because it
displays the configuration information in an easy-to-use format.
Open the ipkey folder, right-click ifcfg-eth0, and click Properties.