Overland Storage REO 9000 - Manual (Page 39)

Configuring the Management System W 39
CHAPTER
4 Configuring the Management
System
The main steps involved in configuring the management system include:
Step 1 Establishing communication with the REO Appliance by mapping it to a
drive letter (Windows only).
Step 2 Verifying that the gateway and Management Port information are
correct.
Step 3 Entering the GbE Data Port, Fibre Channel, and system information.
Step 4 Setting up your logon information.
Step 5 Configuring e-mail alerts.
Step 6 Setting the applicable time zone information.
The images shown in the following sections might appear slightly
different if you are using a different browser or a UNIX-based system.
Mapping a Network Drive to the REO Appliance
(Windows Only)
To access the components used for installation and configuration of the
REO Appliance, you must map a network drive from the REO Appliance
to the system that will operate the REO Appliance console.
1 Make sure that REO SoftKey is still inserted in a USB port on the REO
Appliance.
2 Right-click My Computer on your desktop, and click Map Network
Drive.