Roland VS-1680 - Manual (Page 116)

Rate
Adjust the rate at which flanger is modulated.
Depth
Adjust the depth of modulation for the flanger.
Manual
Adjust the center frequency at which the flanging
effect will be applied.
Reso (Resonance)
Adjust the amount of resonance. Raising this value
will produce a more characteristic effect. Excessive set-
tings of this value may produce oscillation.
CrossFBLvL (Cross Feedback Level)
Adjust the amount of flanging sound which will be
returned to the other channel. Excessively high set-
tings may produce oscillation.
EfxLvl (Effect Level)
Adjust the volume of the Flanger.
DirLvl (Direct Level)
Adjust the volume of the direct sound.
Phs (Phaser)
Phaser is an effect that adds a phase-shifted sound to
the direct sound, making the sound more spacious.
Sw (Switch)
Turn the Phaser on/off.
Mode
Select the number of stages in the phaser (4, 8, 12, 16).
Pol (Polarity)
Select whether the left and right phase of the modula-
tion will be the same or the opposite.
Inv:
The left and right phase will be opposite. When
inputting a mono source, this spreads the
sound.
Sync: The left and right phase will be the same. Select
this when inputting a stereo source.
Rate
Adjust the rate at which the phaser will modulate.
Depth
Adjust the depth of the phaser effect.
Manual
Adjust the center frequency at which the phaser effect
will apply.
Reso (Resonance)
Adjust the amount of resonance. Raising this value
will produce a more distinctive tone. Excessively high
settings may cause the sound to distort. When using a
phaser with many stages, excessively high settings
may produce oscillation.
CrossFBLvL (Cross Feedback Level)
Adjust the amount of phased sound which will be
returned to the other channel. Excessively high set-
tings may produce oscillation.
EfxLvl (Effect Level)
Adjust the volume of the Phaser.
DirLvl (Direct Level)
Adjust the volume of the direct sound.
Lmt (Limiter/De-esser)
This can be used either as a limiter or as a de-esser. A
limiter holds down high signal levels to prevent dis-
tortion. A de-esser cuts the sibilant sounds of a voice,
producing a gentler tone.
Sw (Switch)
Turn the Limiter/De-esser on/off.
Mode
Select whether the effect will function as a limiter or as
a de-esser.
Thresh (Limitter Threshold)
Adjust the level (Threshold Level) at which the limiter
will begin to operate.
Release (Limiter Release)
Adjust the time until when the limiter will turn off
after the input level falls below the threshold level.
Level (Limiter Level)
Adjust the volume of the sound that passes through
the limiter.
Function of Each Effect Parameter
116