Roland ATELIER Combo AT-350C - Manual (Page 78)

78
Re-recording
You can record over recorded performance data.
1 4 5 2
3
1. Press the [Bwd] button or the [Fwd] button to select the desired measure (bar) when you start recording.
If you wish to start recording from the beginning of the song, press the [Reset] button.
2. Press the [Rec] button to enter recording standby mode.
The [Rec] button indicator will light, and the [Play/Stop] button and the unrecorded track buttons will blink.
The track buttons that are already recorded will light.
3. Press the button of the track you want to record, so it’s blinking.
The existing performance data in the specified track will be erased as recording takes place.
* When the button for a track lights steadily, it means it won’t be recorded.
4. Press the [Play/Stop] button to start recording.
When you press [Play/Stop] button, the metronome will sound a two-measure count, and then recording will begin. As you listen to the performance
data previously recorded, record the Part into a new Track.
5. Press [Play/Stop] button to stop recording.
The track button for which performance data has been recorded will be lit.
* If you wish to re-record with different settings for voices, tempo, part balance, erase the recorded song (p. 84) and re-record again. If the Control
track still contains data from before you re-recorded, the volume or sounds may change during playback.
* If you wish to keep the existing Expression Pedal data, and record only the panel operations, you can make settings to prevent the operation of
the Expression Pedal from being recorded (p. 94).