Roland ATELIER Combo AT-350C - Manual (Page 26)

26
Connecting expression pedals and pedal
switches
You can connect an expression pedal (EV-7; sold separately) and pedal
switches (DP series; sold separately) to the Pedal jacks on the rear
panel.
Expression pedal
Pedal jack
Foot switch
Foot switch
Connected jack Explanation
Pedal (Damper) jack
The pedal switch will sustain the notes played
on the lower keyboard (p. 56).
Pedal (Expression) jack
The expression pedal will adjust the overall
volume (p. 55).
Pedal (Control) jack
The pedal switch will control the function
that’s assigned to the right foot switch of the
pedalboard (PK series; sold separately) (p. 93).
* Use only the specified expression pedal (EV-7; sold separately). By
connecting any other expression pedal, you risk causing malfunc-
tion and/or damage to the unit.
Using the USB Memory
Songs you record on the ATELIER and registration sets you create can
be copied to separately available USB memory for safekeeping.
You can also play back SMF music files saved on USB memory (p. 88).
MEMO
If you’re using new USB memory, you’ll need to initialize (format)
it on the ATELIER. For details, refer to “Formatting a USB Memory
(Format Media)” (p. 104).
1. Connect your USB memory to the USB Memory connector.
USB Memory
connector
USB Memory
* Carefully insert the USB memories all the way in—until it is firmly in
place.
* Use USB memory available from Roland. Proper operation cannot be
guaranteed if other USB device is used.
*