Roland ATELIER Combo AT-350C - Manual (Page 21)

21
Getting Ready
Attaching the Music Rest
1. Remove the two music rest fastening screws from the rear
panel.
2. Tighten the two screws to fasten the music rest in place.
NOTE!
• When attaching the music rest, support it securely with your hand
so that it does not fall.
• Be careful not to pinch your hand or fingers when attaching the
music rest.
• Use only the included screws.
• To detach the music rest, support it with your hand and slowly
remove the screws. After detaching the music rest, firmly tighten
the fastening screws.
• The music rest fastening screws you remove must be kept out
of the reach of small children so that they will not be swallowed
accidentally.
Connecting the AC adaptor
1. Make sure that the [POWER] switch is off (outward position).
2. Connect the included AC adaptor to the DC In jack located
on the ATELIER’s rear panel, and plug the power cord into an
electrical outlet.
Indicator
Power cord
To AC outlet
AC adaptor
If you do not wish to attach the AC adaptor to the bottom of the
ATELIER, place the AC adaptor so that the surface with the indicator
(see illustration) is facing upward.
The indicator will light when you plug the AC adaptor into an AC
outlet.
Placing the ATELIER on a stand
If you wish to use the ATELIER while it is placed on a stand, attach the
AC adaptor to the bottom of the instrument.
Orient the AC adaptor so that its printed surface is against the bottom
of the instrument (upward) and its indicator is facing down, and fasten
it with the strap.
Band AC adaptor
* Fasten the AC adaptor securely so that it does not fall.
* When removing the ATELIER from a stand, always be sure to first
detach the AC adaptor from the bottom panel of the instrument.