Roland ATELIER 5100001499 - Manual (Page 20)

18
Before You Start Playing
I
If you’re using headphones, you can use the cord hook to
neatly bundle the cables near your feet.
Attaching the Cord Hook
1. Screw the cord hook (with wing nut) about
80% of the way into the screw hole located at
the bottom left of the ATELIER.
2. After you’ve oriented the hook as desired, use
the wing nut to fasten it.
The settings stored in the ATELIER can be returned to their
factory settings. This function is called “Factory Reset.”
1. Turn down the volume to the minimum level,
then turn off the power.
2. While holding down the [One Touch Program]
button, press the [Power On] switch to turn the
power on.
fig.01-15
Do not turn off the power while the following screen is
displayed.
fig.01-16
When factory reset is completed, the basic screen
appears.
To return all settings other than the User memory settings to
their original factory conditions, refer to “Panel Reset“ (p.
114).
Loading factory default settings will erase any Registrations
currently in the memory of the ATELIER.To save the
Registrations you are currently using, refer to “Saving
Registration Sets” (p. 61).
To return only the User memory settings to their original
factory conditions, refer to “User Memory Reset“(p. 114).
You can adjust the contrast of the screen.
1. Turn the [LCD Contrast] knob (p. 116) located
at the bottom of the ATELIER to adjust the
contrast of the screen.
Using the Cord Hook
Restoring All the Factory
Default Settings (Factory Reset)
Screwhole
Wing Nut
Cord hook
Adjusting the Contrast of the
Screen
NOTE
NOTE
NOTE
NOTE
Bright Dark
AT-75_e.book 18 ページ ２００８年８月２１日 木曜日 午前１０時９分