Roland ATELIER 5100001499 - Manual (Page 127)

125
Error Message
Appendices
Error Message
Error Message Meanings
Copy Protected.
Can’t Save.
To protect the copyright, this music file cannot be saved as SMF format.
Write-Protected
Media. The protect tab of the storage media is set to the Protect (write prohibit) position.
Move the tab to the Write (write permit) position and try the operation again.
Can’t Save
This Song.
You can only play the music data. It cannot be saved on a storage media.
Master Disk
This storage media does not allow initialization or saving. Insert a different storage media and try the
operation again.
Read Only File. You cannot overwrite-save or delete a file on this storage media.
No Media Storage media is not connected. Please connect storage media.
Media Full
Saving is not possible because the storage media does not have enough space. Please use other storage
media that has been formatted by the ATELIER.
Unknown Media This storage media cannot be used. Please format it.
Media Ejected The storage media was disconnected while it was being accessed. Please try the operation again.
Damaged Media A damaged area was found on the storage media.
Can’t Read This data cannot be read.
Can’t Play
Playback was halted because the song could not be read fast enough.
The song could not be read from the storage media fast enough for playback. Press the [Reset] button, then
press the [Play/Stop] button once again.
No Rhythm
There is no Rhythm in User memory.
The Rhythm used by the selected Registration was deleted from User memory, or its order was changed.
Memory Full
The song data is excessively large, and cannot be loaded.
The performance data is excessively large, and cannot be loaded.
The data cannot be stored in User memory since User memory is full.
Recording or editing is not possible because the memory of the ATELIER is full.
MIDI Buffer Full
The ATELIER cannot deal with the excessive MIDI data sent from the external MIDI device. Reduce the amount
of MIDI data sent to the ATELIER.
Communication
Error
A MIDI cable or computer cable has been disconnected. Connect it properly and securely.
The ATELIER is unable to handle the data that was sent. Please send data that the ATELIER is able to handle.
A MIDI
transmission error
has occurred.
Data transfer failed. Please transfer the data again.
Memory Error
An error occurred in internal memory. Please perform the operation again. If this indication appears even
after you’ve repeated the operation several times, please contact Roland service.
This is registration
data of a type that
is not supported.
This instrument cannot use this Registration.
The Ext Memory
port was subjected
to excessive
current.
USB memory not supported by the ATELIER was connected. This USB memory cannot be used with the
ATELIER.
AT-75_e.book 125 ページ ２００８年８月２１日 木曜日 午前１０時９分