Roland SC-88 Pro - Manual (Page 120)

■ Initialize
● Initialize all Parts to the factory settings
This procedure will initialize all the settings of this unit to the factory settings. This will
also initialize System parameters (p.36) and User parameters (p.96).
1.
While holding down [SELECT], simultaneously press both the INSTRU-
MENT [ l l l l ] [ r r r r ] buttons.
The display will ask “ Init All, Sure? ”.
2.
To initialize, press [ALL].
To quit without initializing, press [MUTE].
* After the initialization has been performed, the indications in the display for the parameters listed
below will show the factory default settings. In fact, however, the settings will not yet at that point
be at the defaults. They will be placed at the defaults after you turn power on, then off again.
In Mode, OUT/THRU, IN B Sel. ( p.135)
● Initialize for GM/GS
When you wish to playback song data carrying the GM/GS logo, you need to initialize
this unit for GM/GS settings. When this is done, this unit will be set to the basic GM/GS
settings appropriate for playing back song data carrying the GM/GS logo.
The beginning of song data carrying the GM/GS logo contains data which requests
the sound source to initialize itself (General MIDI System On, GS Reset p.133). This
means that if you are playing back the song data from the beginning, initialization will be
done automatically, and there is no need for you to do it using the front panel buttons.
* Even if this unit is initialized for GS/GM, the System parameter settings (p.36) will not be affected.
* Even if the Backup Switch ( p.37) is on, the following procedure will rewrite it to the factory setting.
1.
(For GM) While holding down [SELECT], press PART [ r r r r ].
(For GS) While holding down [SELECT], press INSTRUMENT [ r r r r ].
The display will ask “ Init GM, Sure? ” or “ Init GS, Sure? ”
If you perform this operation in Double Module mode (p.116), the display will ask “ Init
GS A, Sure? ”. Use INSTRUMENT [ l ] [ r ] to specify which module A or B will be ini-
tialized.
2.
To initialize, press [ALL].
To quit without initializing, press [MUTE].
INSTRUMENT PART
LEVEL PAN
REVERB CHORUS
KEY SHIFT MIDI CH
SELECT
EFX ON/OFF
USER
INST
VIB RATE
ATTACK
VIB DEPTH
CUTOFF
DECAY
VIB DELAY
RESONANCE
RELEASE
DELAY
EFX VALUE EFX PARAM EFX TYPE
ALL
MUTE
SC-55
MAP
SC-88
MAP
1
1 2
GM ALL
1 GS
1
Chapter 5. Convenient functions 118