National Instruments NI-FBUS - Manual (Page 84)

Chapter 4 Parameters
© National Instruments Corporation 4-19 NI-FBUS Configurator User Manual
FSTATE_TIME (Faultstate, Option)
Time (in seconds) to delay from the detection of loss of communications
with the host for the output block remotes setpoint until the enaction of the
fault state output.
FSTATE_VAL (Faultstate, Option)
The setpoint value to be used on failure.
Note The I/O option Failsafe to value must be selected.
FSTATE_VAL_D (Faultstate, Option)
The discrete setpoint value to be used on failure.
Note The I/O option Failsafe to value must be selected.
GAIN (Tuning)
The gain constant used by the PID in calculating the proportional
component of the output.
GRANT_DENY (Option)
Allows HMI applications to determine access privileges for block
parameters.
Note The device does not use this parameter to restrict parameter access itself. It is only
for the benefit of host applications.
HARD_TYPES (I/O, Process)
A list of available channel types. As I/O modules are inserted and removed
from the FP-3000 bank, bits in this field change to reflect the presence or
absence of types of I/O channels.
Table 4-13. Hard Types
Bitmask Description
Analog Input This bit is set if the FP-3000 has analog input
channels available.
Analog Output This bit is set if the FP-3000 has analog output
channels available.