Table 4-4. scaling parameters, I/o parameters, Limiting parameters – National Instruments NI-FBUS User Manual
Page 72: Table 4-5. limiting parameters, I/o parameters -7 limiting parameters -7
Chapter 4
Parameters
© National Instruments Corporation
4-7
NI-FBUS Configurator User Manual
I/O Parameters
I/O parameters are related to the physical I/O. The I/O parameters are as
follows.
CHANNEL
HARD_TYPES
IO_OPTS
LOW_CUT
Limiting Parameters
Limiting is to prevent a calculated value (from a PID block, for example)
from rising above or dropping below a certain value.
Table 4-4. Scaling Parameters
BYPASS
I/O_OPTS
READBACK
CONTROL_OPTS
L_TYPE
READBACK_D
FF_GAIN
LOW_CUT
SEL_1
through
SEL_3
FF_SCALE
OUT
SEL_TYPE
FF_VAL
OUT_SCALE
TRK_IN_D
FIELD_VAL
PV
TRK_SCALE
FIELD_VAL_D
PV_FTIME
TRK_VAL
IN
PV_SCALE
XD_SCALE
IN_1
—
—
Table 4-5. Limiting Parameters
BKCAL_HYS
SP_LO_LIM
OUT_HI_LIM
SP_RATE_DN
OUT_LO_LIM
SP_RATE_UP
SP_HI_LIM
STATUS_OPTS