Nortel Networks NN43001-504 - Manual (Page 159)

Configuration 159
The WLAN Application Gateway 2246 uses the following pins on the
connector.
Table 19
Pins on the connector
Pin Function
1 Carrier Detect
2 Data OAI Receives
3 Data OAI Transmits
5 Ground
7 Ready to Send
8 Clear to Send
Connect to the Application Server through the LAN
The IP address must be configured for the WLAN Application Gateway 2246
to function on the LAN. Follow the application instructions to identify the
WLAN Application Gateway 2246 to the application.
Figure 27
WLAN Application Gateway 2246 connection to Application Server through the LAN
Connect to Application Server through a modem
Connect the modem to the Gateway serial port using a cable that conforms
to RS-232 standards for DTE-to-DCE connections. See
Figure 28 "WLAN
Application Gateway 2246 connection to Application Server through a
modem" (page 160)
.
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.