Nortel Networks NN43001-504 - Manual (Page 158)

158 Appendix A WLAN Application Gateway 2246
—End—
All components cycle through their usual diagnostic routine.
Connecting to the Application Server
Some applications can require a LAN connection between the Application
Server and the WLAN Application Gateway 2246. If the applications do
not require a LAN connection, use the RS-232 port connection. In some
situations, a modem is connected to be used for remote administration of
the WLAN Application Gateway 2246.
Connect to the Application Server through an RS-232 port
Some applications or systems can require an RS-232 connection between
the Application Server and the WLAN Application Gateway 2246. If the
applications have the ability to communicate messages over TCP/IP, and
do not require a serial connection, the RS-232 cabling is not required. In
that case, the LAN connection (port 5456) through the Ethernet switch can
be used for the applications.
Connect the Application Server to the WLAN Application Gateway 2246
serial port by using a cable that conforms to RS-232 standards for
DTE-to-DTE connections (null modem cable).
Figure 26
RS-232 cable connection
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Copyright © 2004-2007, Nortel Networks
.