Configuration – Nortel Networks NN43001-504 User Manual

Page 153

Configuration

153

•

Bits per second: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: None

Note: If using Windows 2000, Service Pack 2 must be installed
to enable the use of HyperTerminal™.

Reset the system.

The following appears on the terminal display:

04830130

Type the following command using the terminal or PC keyboard:

0255CC [CTRL M] [CTRL J]

The command does not display on the screen as it is typed.

The Login prompt appears. If an error is made when entering the
command string, the message

Ill Formed Packet

appears. It

appears as a series of numbers followed by some form of the typed
command. If this occurs, repeat

Step 3

and

Step 4

Enter the default logon name and the default password:

admin

Note: The logon name and password are case-sensitive.

The NetLink OAI System screen appears. This screen, the
main menu screen of the Administration Console, displays the
factory-default name of the WLAN Application Gateway 2246 to
which the serial port is connected

—End—

Next, configure the WLAN Application Gateway (including IP address) by
following the steps in the

"Task summary list" (page 154)

Configuration

The NetLink OAI System screen is the main menu of the Administration
Console. Use this screen to configure the WLAN Application Gateway 2246.

Nortel Communication Server 1000

WLAN IP Telephony Installation and Commissioning

NN43001-504

01.02

Standard

Release 5.0

15 June 2007