Paradyne 3163 - Manual (Page 92)

ACCULINK 3163 DSU/CSU
C-16 March 1999 3163-A2-GB20-10
Table C-6
(5 of 5)
User Interface Configuration Options
TnSession: Disab
Next Enab Disab Prev
Telnet Session Enable. Specifies whether the DSU/CSU responds to Telnet session requests.
Enab – The DSU/CSU responds to Telnet session requests.
Disab – The DSU/CSU does not respond to Telnet session requests.
TnPaswd: Disab
Next Enab Disab Prev
Telnet Password Mode. Specifies whether a password is required for Telnet access.
Enab – A password is required for Telnet access.
Disab – A password is not required for Telnet access.
TnInActTm: Disab
Next Enab Disab Prev
Telnet Inactivity Timeout. Specifies whether the Telnet session disconnects after a period of inactivity specified by the
TnDiscTm configuration option.
Enab – The Telnet session disconnects after the period of inactivity specified by the TnDiscTm configuration option.
Disab – The Telnet session does not disconnect due to inactivity.
TnDiscTm: 5
Next Up Down Save Prev
Telnet Disconnect Time. Specifies the period of time (1 to 60 minutes) before the Telnet session disconnects due to
inactivity. (The TnInActTm configuration option must be set to Enab.) Use the left or right arrow key to position the cursor
on the digit you want to change. Use the Function keys (Up or Down) to increment or decrement the digit.
Up – Increments the time delay.
Down – Decrements the time delay.
Save – Stores the time delay for use with inactivity disconnects.