Paradyne 3163 - Manual (Page 78)

ACCULINK 3163 DSU/CSU
C-2 March 1999 3163-A2-GB20-10
Network Interface
Configuration Options
Table C-1
(1 of 2)
Network Interface Configuration Options
NET Framing: ESF (Factory 1) D4 (Factory 2)
Next D4 ESF Prev
Network Line Framing Format. The framing format to be used on the network interface.
D4 – Configures for the D4 framing format.
ESF – Configures for the Extended Superframe format.
NET Coding: B8ZS (Factory 1) AMI (Factory 2)
Next AMI B8ZS Prev
Network Line Coding Format. The line coding format to be used on the network interface.
AMI – Configures for the Alternate Mark Inversion coding format.
B8ZS – Configures for the Bipolar 8 Zero Suppression coding format.
LBO: 0.0
Next 0.0 –7.5 –15 –22.5 Prev
Line Build Out. The line build out (LBO) for the signal transmitted to the network (0.0 dB is the factory default).
ANSI PRM: Disab
Next Enab Disab Prev
Generate ANSI Performance Report Messages. Specifies whether ANSI T1.403 compliant performance report
messages (PRMs) are generated.
Enab – Generates and sends ANSI PRMs over the FDL every second.
Disab – Prevents the DSU/CSU from generating ANSI PRMs.
NOTE: This configuration option is only available if the framing format is set to ESF.
Mgmt Link: Disab
Next Enab Disab Prev
FDL Management Link. Specifies whether Facility Data Link (FDL) is enabled. Selecting Enab allows Telnet traffic to flow
over the 4 kbps data link provided by FDL. Running Telnet over FDL requires an end-to-end FDL connection and cannot
be terminated within the network.
Enab – Enables the FDL management link for Telnet.
Disab – Disables the FDL management link.
NOTE: This configuration option is only available if the framing format is set to ESF.
NOTE: If the local DSU/CSU’s FDL is enabled, the remote DSU/CSU’s FDL must also be enabled.