Paradyne 3163 - Manual (Page 49)

Operation
3-27 3163-A2-GB20-10 March 1999
4. From the Call Setup screen, select Dial. This
selection is not available if the DSU/CSU’s
integral modem is already in use.
F1
Call Setup:
Pass
Dial ChDir
F2 F3
5. From the Dial Directory screen, press F1 (Up) to
display the next higher numbered directory or
press F2 (Down) to select the next lower
numbered directory.
F1
Dial n: xxxxxxxxx
Up Down Dial
F2 F3
6. When the number of the desired directory appears
on the screen, press F3 (Dial) to place the call.
F1
Dial n: xxxxxxxxx
Up Down Dial
F2 F3
Disconnecting the Modem Connection
The Disconnect command enables you to force a
disconnect of an active modem connection from the front
panel of the DSU/CSU. This command is only available
when the DSU/CSU modem is connected.
Disconnect methods include:
•
Using the Disconnect command via the front panel
menu (for all dial connections, or when a
pass-through connection is established to another
316x DSU/CSU).
•
Pressing and holding the and front panel
keys simultaneously (when a pass-through
connection is established to a remote device other
than a 316x DSU/CSU).
"
Procedure
To disconnect an established modem connection using
the Disconnect command:
1. From the top-level menu screen, press the key
until the Ctrl selection appears on the screen.
2. Select Ctrl.
3. From the Control screen, select Call.
F1
Control:
Call
Rel LED
F2 F3
4. From the Call Setup screen, select Disc.
F1
Call Setup:
Disc
ChDir
F2 F3
The modem call is disconnected and the
Command Complete screen appears.
F1
Disconnect:
Command Complete
F2 F3